My only problem with the clueboard is no support for in switch leds. Other than that I wouldn’t mind buying one
Sent from my iPhone using Tapatalk
I don't really care for in switch LEDs myself, so actually just installed a Clueboard PCB into my St :-)
As an FYI for anyone else that might be considering this:
1. The Clueboard PCB as shipped will not work with the spacer, as the CB PCB does not have clipped corners, you will either need to clip or file the corners on the PCB or file out the inside corner of the spacer to make room
2. If you don't use the spacer, there is not sufficient clearance in the case for the clueboard pcb reset switch
I just unsoldered the reset switch since under QMK you can map a key combo to reset, and worst case short the pins. Since the switch is not externally accessible in the ST case (unlike the CB case) this is not a big deal.