geekhack Marketplace > Interest Checks

[IC] DESØLATION • Polymount 60% keyboard

<< < (2/3) > >>

Anorexious:

--- Quote from: The0rigina1 on Sat, 25 May 2024, 02:49:50 ---If it's magnets holding the top and bottom together, wouldn't it snap shut when you're assembling the board and therefore scratching the ano?

--- End quote ---

I've tested this for around 3 months now and haven't seen any scratches, especially in the contact area, although yes it will have more risk compared to a conventional lock mechanism
By design, it has a slight tolerance that minimizes this from happening

Pros you can easily assemble without any screwdriver but cons you need to be more careful compared to screw mechanism

Azernith:
Make Bottom mount great again  :cool:
glwic

pseudonym:
You state that you want to offer ANSI-blocker as well as WKL - isn't that the same? I'd prefer a board with WK.

Anorexious:

--- Quote from: pseudonym on Sun, 26 May 2024, 17:52:53 ---You state that you want to offer ANSI-blocker as well as WKL - isn't that the same? I'd prefer a board with WK.

--- End quote ---

Yes you can check on the design section for preview WK layout

nathanchere:
Looks like at the very least the USB connector placement would prevent using a generic (e.g. GZ60) board with this, so my usual plea applies. Please consider adding split spacebar support (2.25+1.5+2.75) or similar.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version