has anyone tried to add underglow strips?
Also looking for this answer, I want to add unnecessary RGB to all my stuff plz
I was able to solder WS1812 strips to the back of the PCB. Connect the 5v wire to the V pin on the PCB, Data to O, and Ground to G. It's an "open circuit", the arrows should be pointing away, and you don't need to 'close' the circuit by adding more wires.
However, there isn't enough space for the LEDs in the case so you may have to sand the bottom case.
Do you have any pictures of your set up? And are you saying that if you were to add individual rgb lights to the back or a stand-alone strip there’d be no space within the case? Thanks!
just wanted to share how I wired up my RGB strips
https://imgur.com/a/aAavK1d5V and GND are parallel between all the LED's, so you can bridge any two respective pads for >1 strip
Data In is series, so it starts at one end and you must bridge each discontinuity.
I ordered my strips from keebio, these seem to fit the hotswap pcb just fine. I would suppose the regular pcb has more clearance.
Also remember to correct the qty of LED's in the config.h file. Hope this helps.