geekhack Community > geekhack Media
OTD 360c build log
_rubik:
--- Quote from: Sup on Sun, 31 March 2024, 21:21:42 ---
--- Quote from: _rubik on Tue, 26 March 2024, 18:16:59 ---
--- Quote from: Sup on Sat, 23 March 2024, 15:45:27 ---Nice build, but those SMD could have been soldered way better. Try using tweezers makes it a breeze still takes good amount of time though.
--- End quote ---
For my edification, what do you mean by "using tweezers". I still do what OP did -- pull the legs through, bend them over so they don't fall over, flip the board, and tack them in place.
--- End quote ---
I am talking about the SMD diodes not the trough hole ones. Not everything is babied for you with old kits or niche kits ;)
--- End quote ---
Oh right right, yes. Hot air flow station or bust. But then again, it's totally overkill for a single kit
Navigation
[0] Message Index
[*] Previous page
Go to full version