Damm, not a bad deal on that Mini, would have been very tempting. I think its my favorite layout.
Same, it seems like there is enough interest to run a GB, but someone would have to design the PCB.
I'd be down for one and I could help with the pcb.
I could help with designing the plates, but that is what I am limited to, my brother knows how to 3d model, so he might be able to help me actually model a case after I get the measurements done in a 2d CAD
I have plenty of plate and 3D experience, if someone could give me measurements for the F block I'd be good.
width wise it would be 1.8mm+1.8mm for the cap sizes, and then 1.05mm for the space between the keys, and then .525 for each side of the keys to the case, so thats 1.05mm. Width = 5.7mm with those specs, so then vertical would be 1.8 * 5 + 1.05 * 5 (4 for between the keys, and the 5th for the spaces combined to the case) so 9 + 5.25 = 14.25 vert. So 5.7cm x 14.25cm, and if you want 1.05 spacing between the key and the case, just add 1.05 to each of the measurements, so that would be 6.75cm x 15.3cm