Certainly nice to see Keychron branching into the enthusiast market considering that my first real mechanical keyboard was a Keychron K2
May be a little too late, but would suggest the following:
- If plate flex is an intended part of the design, would suggest removing the side tabs
- The front height of 21.6mm is on the high side, especially in the enthusiast market where most can go as low as 17mm. The high front height is an issue that has plagued existing Keychrons as well, so I feel that this should not be ignored.
- Assuming the layout is fixed, keys on the right of space bar should be 1.5u/1.5u. 1u mods are less preferred.
- Angle at 5.2 degrees seems on the low side.
Other than that, I think this can be a really good option for a fully assembled off the shelf option!