« previous next »
Pages: « 1 [2]   All   Go Down

Author Topic: [IC] Eros by Enigo | F13 TKL | GB Details and Vendor Announced |  (Read 22715 times)

0 Members and 1 Guest are viewing this topic.

Offline philipb

  • Thread Starter
  • Posts: 23
  • Enigo designs
Re: [IC] Eros by Phil | F13 TKL | GB Details and Vendor Announced |
« Reply #50 on: Sat, 28 May 2022, 22:43:19 »
Quote from: granola bar enthusiast on Fri, 27 May 2022, 10:26:54
is there any chance for a polypropylene plate? also, pls don't ditch the gummy o-ring compatibility, would be a turn off to a lot of people

I have been considering PP heavily along with a few other plate options.

In regards to gummy o-ring compatibility, don't see a reason not to keep it! It is easy enough to add and doesn't change anything significant.
Logged

Offline philipb

  • Thread Starter
  • Posts: 23
  • Enigo designs
Re: [IC] Eros by Enigo | F13 TKL | GB Details and Vendor Announced |
« Reply #51 on: Tue, 01 August 2023, 00:08:03 »
Hello everyone! Hope you are doing well.

I have good news to report: the final prototype for the Eros TKL has been completed. It will be built by my good friend, Andy Nguyen, on Tuesday 8/1/23 at 5:30pm PST. You can find his twitch channel here: https://www.twitch.tv/andyvnguyen.

More information about the GB will be available as soon as the details get ironed out. Thank you again for all your support with this project! We are finally nearing a close.
Logged

Offline SDKCAMPING

  • Posts: 183
Re: [IC] Eros by Enigo | F13 TKL | GB Details and Vendor Announced |
« Reply #52 on: Sat, 05 August 2023, 01:53:19 »
Glad to see this is still alive 👍
Logged
Blue Gray Ciel 60 with BCPs | E-white 7V (plateless) with Aqua Kings
Pages: « 1 [2]   All   Go Up
« previous next »