Hey Sprit,
Updated my order according to the new developments
Is the metal case design more or less finalised then? Can we really mix and match with acrylic? Is it ok to order a selection of just the middle layers in acrylic for example, to add to the case later?
Hello! MrChunky!
The Uniform Bottom Flatform is actully the key in my concept. It shares all the dimensions and holes with Metal and Acrylic.The Metal design shares the Bottom Flatform Layer with Acrylic, as You guys seen! The Metal versions need to be finalized for the corner and edge angles. It is 2- or 3- layered, You can mix the Layers with any material (metal, Acrylic, or any in the future)
I will show 2-layered Model 2 Cases for Round 2 very soon, looking a little bit slim (hight : Model 1 (28mm), Model 2 = (21mm), sharing the Bottom and Middle Layer with Model 1 too!
Model 1 & 2 Cases will be available Always, all together.
I am focusing on Round 1 Shipping, it will end soon hopely!
When each order is ready to ship, I will message each of You, so dont worry please!