I finished up a ergodox a couple weeks ago, and I'd like to take what I learned a little further. I've found plenty of tutorials for wiring the switches together, but I haven't found a solid explanation on how to wire it to a controller and then write the code for a matrix.
I'd just like to wire up a simple 1 layer 10 key or something along that lines and then work through writing the code or modifying code for it so that I can better understand the software side of what is going on. I'm familiar with the teensy controller only because that is what I used on the Ergodox, but I'm open to suggestions on that subject.
Any direction would be appreciated. I dug through a couple "living thread and made some searches, but I didn't see what I was looking for.
-Crit