geekhack Community > Input Devices

Logitech G502 board inside 3d printed Logitech G9X body


Can someone help me with this project? I don't know where to cut along the G9X board (first 2 photos) to keep the mouse switches + mouse wheel in a viable state.

or, alternatively: the entire album.
If I can cut the upper part of the G9X board and lower it so I have enough clearance to push down the top shell of the mouse, then everything will fit. I was planning to recreate the top shell down the road once I finalize this stuff anyway. I don't know what I'm doing lol (haven't done anything yet.)

I'm following this guide: at around step 7.
pls halp.


[0] Message Index

Go to full version