Well, as I said and litster confirmed, it is no issue´, but the question remains: Is it the only one, and have someone gotten one where they have missed a more critical hole? It seems weird to me that a proces which ought to be CNC could even yield such a deficiency.
I have a couple of thoughts I would like to have confirmed:
A) So far, no one as implemented the mx lock switch in the firmware, correct?
B) The LEDs are connected in parallel with their counterparts under the caps. Both of them could thus be used, 4 LEDs in total, correct?
C) Are the resistors located before or after the junction where the LEDs go parallel? I am assuming that they are located within the split and both will have to be used if one wants both Caps lock LEDs to light up, on resistor for each LED. I am planning to connect both and use a small switch to select which one I want to use.