Hello i wanted to share this simple 40% which was my first handwired project. I used Pro Micro controller which was pretty easy to flash with kbfirmware.
The chip is not secured in any way and you need to mark it where it needs to be when you start soldering. The design has small left-right tolerance. After assembling i had no issues with plugging in.
The reason why i did it this way is because i wanted to make it top mount. I made the plate 2mm which is pretty soft.
I attached everything here so you can modify.
I needed:
10 threaded inserts M2.5
3 M2.5 x 16
3 M2.5 x 8
4 M2.5 x 4
Most probably people already did this but there you go
