For Alienman82.
Show Image
I hated putting this thing together, mainly because of the spacers, haha.
Now to finally work on Naasfu's Corsa!
ahh so the truth is out. where is my board? aliens.
cp sq is looking good. :) E3E, what spacers are you talking about? the middle acrylic layer?
Hahaha, an alien abduction!
Well, the middle acrylic portion has these little oblong and round spacers that go into each area where screws are used for mounting the plate and top cover. They're used to give the plate clearance over the bottom portion. There are small steel threaded inserts that go into the board from the bottom and everything is just so loose once you take the middle layer off that it all just kind of scattered immediately after I took the middle piece off of the case (the case came assembled, haha).
Was a PITA to find all the spacers and especially reassembling the case. I used tape to hold everything together while I was securing the plate and top bezel. :confused: