I got my Jane 3 days ago and finally today had time to build it! I'll post some pics when I am fully finished, but I have one problem and one question.
Problem: The minus key (between 0 and =) on my Jane doesn't function. When I was testing the switches post soldering, I noticed it was the only key that did not work. So I desoldered that switch and put in a new one. It still didn't work. So I assumed it was a mapping issue since multiple keys were mapped incorrectly. I completed the build and then installed and launched the JigOn_151116 software. I remapped several keys to my preference, but the minus key was correctly mapped to minus by default. It's clear that the key isn't working from the JigOn software because when the keyboard is connected to the software pressing the minus does nothing, the software doesn't see that the key has been pressed. The software detects all other keys being pressed. I already tried two switches in case one was bad and soldered the switch the same as I did the other 86 keys.
Any advice? It seems that the PCB is defective if a key does not function?
Question: Do you guys have any tips/guides on soldering the RGB LEDs? I noticed a corner triangle on the PCB and LEDs that seems to indicate an orientation. On my PCB, RGB1 and RGB2 have holes in the PCB slightly larger than the LEDs so is there something different that needs to be done with those two? I have not soldered something like that before but it seems like it would be very difficult since the LEDs are so small and there's nothing to hold them. Thanks.