Problems
I cant make the Teensy stop sending keys, flashed the firmware several times, different setup, desoldered everything again just to make sure I dont have a short somewhere, used 3 different machines and 3 diff cables, same problem.
Im talking about having the Teensy plugged in and nothing soldered to the pins, bare board.
First I had the teensy automatically sending RSHIFT, END, F6, F12, ; and ,.
The first 4 are only sent once at plug-in, last 2 are repeating/looping forever
Went back to the same website, removed and replaced those keys with something radom and re-generated the HEX, flashed the new firmware.
New keys are being sent, RSHIFT, END, F12, PAGEUP, PAGEDOWN
The first 3 are only sent once at plug-in, last 2 are repeating/looping forever
Now, I`ve never used RSHIFT anywhere on my setup so I cant disable that but given the newly added keys all I can only say the website is buggy and the HEX will never work as intended
On previous posts I`ve included the source code generated by same website, if someone can get that and look into it and check if me barking about the website being buggy is legit i`d appreciate it
)
I ordered another teensy, new temperature controlled solderign iron and new type of soldering flux, just to make sure I didnt damaged the circuitry, when the Tennsy gonna be here I`m not gonna solder anything to it but i`ll flash the 2 versions of the firmware.
So, for the next 4, 5 days I`ll focus on something else
On the positve note
I also bought a ball/roller massger, took it apart and now I have a 54mm hard plastic perfectly round ball for under $7
Modelled and printed a case/support for it, I`m gonna use the same sensor ; pmw3360 to create a module or attach it to the right console
Destroyed a small bearing, took the tiny steel bearing balls and heat insterted into the 3d printed support, 3 supports, rolls nice and smooth, not as smooth as the real deal where zirconia balls are being used but is good enough for under $7