How to safely disassemble a QuickFire Pro?

[Sgt_4Leaf]

Hello Ya'll,

I need to open up my Cooler Master CM storm QuickFire Pro (what a short catchy name, huh).
Where can I find reliable data of how to do that properly?

Also, would anyone happen to know if it is normal to be required to type a verification code and the same stupid "A Popular serial bus for keyboard connectivity" question prior to each and every post and reply? 

Thanks in advance,

[SpAmRaY]

I've not disassembled a coolermaster in a few years but if there are any bottom screws remove them, probably one under the sticker.

Then use a spudger or some thin plastic pry tool and carefully separate the top and bottom half, there are probably plastic clips to release.

And the verification goes away after 10 posts I think.

I didn't search but there could be a thread on this buried in the deep.

Sent from my SM-G930V using Tapatalk

[Sgt_4Leaf]

I've not disassembled a coolermaster in a few years but if there are any bottom screws remove them, probably one under the sticker.

Then use a spudger or some thin plastic pry tool and carefully separate the top and bottom half, there are probably plastic clips to release.

And the verification goes away after 10 posts I think.

I didn't search but there could be a thread on this buried in the deep.

Sent from my SM-G930V using Tapatalk

Thanks..

[Sifo]

there was like a whole forum dedicated to modding qfrs lol

but yes it's 1 under the sticker and then pop the clips with a credit card