I would love either a plate if this is still active or a drawing file if somebody can get me one
So, I was going to get a run of these done using jd's design a little over a year ago. I got a prototype one-off made and we figured out that it needed some changes to fit a ducky, but it fit my rosewill fairly well. jd was going to make the necessary changes to the design (which he did) and then I was going to do a run at a cutter that is local to me. I did not get this done before my son was born in October last year, and nothing has really been the same since, lol.
A few months ago, I got back in contact with jd about following through and doing a run of these. I got the most updated cad file from him and got a quote for a run of 50 plates. However, once again, I got busy with life and did not follow through.
I did at least do some work on actual numbers. If the quote the cutter gave me is still accurate, I think I can get these done for about $30 per plate. That covers everything except shipping.
So if there is enough interest for about 50 orders, I can still do this. I would not take any money until plates are in hand. If there's still interest, I will ask to start a group buy.
My time is limited, so I would want to keep the order limited to 50.
So, do people still want these?
EDIT: I should mention, this design fits ANSI only. I did not make the design, all credit for that goes to jd. If you want him to do an ISO design, you can ask him, but this buy will be for ANSI only if I do one. I am not prepared to have it be any more complicated than that.