Hopefully, this would support universal 60% PCB so we can choose whatever PCB we want to use as well as ease of replacement if anything happens.
But it would still be okay if you decide to have a proprietary PCB with a center port location.
I would just like to clarify some things:
1. For the type of gasket, have you decided on the thickness as well as the hardness of the rubber that you will use?
2. I am also a bit concerned on the sides of the plate (left and right) without the rubber gaskets. I hope the tolerances will be tight enough so that it won't touch the bottom and top halves of the case when fully
mounted/screwed.
Hmm... Also, is it too early to ask for the timeline (at least rough estimate) of this gb? Slightly excited on that PC gasket-mount board.
Anyhow, good luck!