Finally got my dream board (LSv1)!
It got in from Korea about a month ago, and I recently finished converting it from MX Whites to Gateron Clears. Unfortunately, during resoldering, a couple traces got lifted (LED traces), does anyone know if its possible to jump these or otherwise make those LEDs functional? I installed SIP sockets in every switch before realizing that some traces were lifted, so currently only 3 of my LEDs are actually soldered -_-
Anyway, here's a picture, forgive the messy desk, I haven't gotten the chance to clean it recently and I spend most of my time here.
Really regretting selling my good camera...