« previous next »
Pages:  [1]     Go Down

Author Topic: Realforce dome cutting  (Read 1069 times)

0 Members and 1 Guest are viewing this topic.

Offline sitch

  • Thread Starter
  • Posts: 259
  • Location: Malaysia
Realforce dome cutting
« on: Wed, 28 October 2015, 09:03:41 »
I have a variable weighted realforce 87, would like to swap all the 45g to the 60% part

Is it easy to cut the dome without breaking it/ lose the tactileness?

what tools do I need to use in cutting?


thanks!!
Logged

Offline SpAmRaY

  • NOT a Moderator
  • * Certified Spammer
  • Posts: 14667
  • Location: ¯\(°_o)/¯
  • because reasons.......
Re: Realforce dome cutting
« Reply #1 on: Wed, 28 October 2015, 09:04:22 »
A nice sharp pair of scissors should be just fine. So long as you are careful you shouldn't have any issues, just pay attention to the way the domes align onto the slider housing.
Logged
Pages:  [1]     Go Up
« previous next »