Hey folks, couple of quick updates.
- Anodizing for grey anodized is going to get pushed back slightly, I have to find alternative M3 screws to hang the parts during anodizing as this was the main driver of QC failed silver units. However, I only had steel screws and my anodizer wants to use aluminum screws and there aren't good sources (the M3 aluminum screw on McMaster is either a standoff or a weird $5/screw part with a thick washer on top, which isn't economical if we need a few hundred of them). Trying to see if we can use Nylon screws instead and hang the parts that way
- Cerakote vendor finally came back and said he has a load for me to pick up, so I'm coordinating with him now on timing.
Other than that, working on polishing plates and shipping out orders - nothing else new from my side.
Thanks!