Lately I have found Signature Plastics fonts crooked, lopped off ETC. Just as bad as a $20 set now. YMMV. I am not sure if I saw 2 bad sets in a row or if their QC is slipping. If this is how it is going to be there is no reason not to buy a $20 set then. Since as you said that was all that differentiated them previously. That is all your $200 bought you. If no longer, than no reason to spend it IMO. TBH I may have just had bad specimens. I certainly hope so. Also 1.4MM is all you need. I would like to see a blind test where you tell the difference between 1.4MM and 1.9MM. Of the same height and profile of course. It is much more important that the board is very solid. I feel a 60-65% board should weigh in excess of 20 pounds. As you all are aware I am crazy as well. However, it is not hard to make a mini board weigh that much either.