Hey Senter, seeing a build stream tonight of a Leaf80 has me a little concerned. There were lots of switch alignment issues and even caps rubbing on the wkl blockers. The images of the Leaf60 proto looks like the seams around the caps are tight too. Is this something that has been addressed since the 80 group buy?
I just watched the recording until finish. Seems like there were three issues when Nathan was building the board.
1. Enter key is a little higher.
2. Several alpha keys are not aligned.
3. Left and right Shift keys are a little lower.
For 1, the issue is gone after Nathan soldered the switch.
For 2 and 3, I guess some keys were not pressed down completely. Pressing the key while soldering them should fix the problem. That was a custom plate but I didn't find any problems with the plate file.
update: Saru confirmed what I said.