Okay, here's what I've tested:
Doesn't fit properly in Klippie (D2 diode is like RIGHT NEXT to the mounting hole) It will go in if you put the PCB off-center which, I will not.
Doesn't fit in the 5degree case from KBDFans. The extra two top screw mounts on that case come into contact with a diode and the hot-swap pieces on the back of the PCB.
Doesn't fit in Aliexpress wooden case (something making contact on the left and also the middle screw support)
Soooo.... I don't have any cases this will work in.
I guess I can put it in my TX60, although I'm not sure how a hotswap board works in a top mount board... maybe it will NOT just fall out? Maybe the PCB mounted stablizers will hold it in? AND I just remembered my TX60 is HHKB layout and this has no split right shift. Hmm... I've got 5 empty cases that this PCB will not go in. This blows.
Anyone have a case this fits in?
So I’ve got an ISO one here, and it works in a 5degree case - a bit of tape over the additional mount stops it shorting.
I have a wooden royal glam case, no issues whatsoever. I’ve got another cheap Ali wooden case that’s low pro - again no issues.
It also works just fine in my tina C, tx60 as top mount (seems held in pretty darn tight).
My klippe and revo also have 0 problems.
Do you have a pic of the pcb? I’m wondering if there is some part that is catching just on your one.
Sent from my iPhone using Tapatalk