Hello,
So after finally building my first keyboard, I am facing some problems, and I am not sure what could be the cause. Maybe some of you experienced the same problems, and could point me in the right direction.
Short description of all the things I did:
1. Check if PCB registers clicks (I didn't check for "correct amount" of clicks, if that is even possible)
2. Lube switches (stem, spring, front and back) with Krytox 205g0
3. Lubed, clipeed and bandaid modded the stabilizers
4. Soldered at 380C° with SN60PB40
So there are 2 weird things going on:
1) They keyboard registers clicks, without clicking the switches. Demonstration:
2) Keys get stuck on repeat, until I press another key. Demonstration:
A few guesses I have, as to what could be wrong:
1. Is it possible, that I got some lube (or dialectric grease) on the PCB, and that somehow ****s things up
2. Bad soldering? First time soldering, I think it looks fine, but maybe you can see something from this picture:
https://imgur.com/a/D1RDBqO3. Maybe I just did a sloppy job on lubing the switches, and i got some lube on the contact plate part, and now that is causing problems?
Thanks in advance for any answers!