After discussing with MM about the mod, I still think it sounds like a good idea, but had no idea what the added cost of that midpoint detachable cable connector was. Hint, it's not inexpensive. However, we are now in talks about making a single cable, sleeved, with usb on one end, and the Filco specific connector on the other. The only work that would possibly be needed for the board itself is to expand the hole with a rasp or file,and a stopper of some kind on the inside, possibly using a zip tie cinched down to act as a stress relief, but it would give it the clean, factory look that I'm going for. What are everyone's thoughts? I'd be down for throwing some cash in for a crimper to get the inner connector attached properly if enough people were interested as well.