Sorry if this has already been asked.. Any chance of a ISO layout? then I would be in for a couple I think. (depending on price ofcourse..)
I don't think jdcarpe would mind drawing up any plate that is wanted. However prices are going to be higher on low quantity plates
Sure, I don't mind drawing plates for any of the plate designs available for the GH60. If someone doesn't mind paying for a low quantity plate, I don't mind drawing it up.
The dimensions include room for the bends, so the best way to go is to modify one of my DWG files using the Escape key as a locator.
Also, I left the LED hole next to the Caps Lock position, but that can probably be deleted for the GH60. Do NOT remove the small strengthening braces in the spacebar slot until AFTER the plates are bent. Otherwise the bending break will distort the spacebar switch hole.
I am also happy to modify or help modify any of the DWG files if desired.
- Ron I samwisekoi
Thanks for the tips. That's actually how I copy and paste most of my designs into others. I pick a reference point, such as the ESC key, and draw a couple lines intersecting at the center of that switch hole. Then copy the existing design, using the center of the same switch hole as a reference, and paste into the new plate. Copy with reference is one of the most-used tricks in my drawings.
Also, thanks for the tip about the spacebar slot. I didn't consider that, but it makes sense. The place where I got my lubing station bent has a machine that uses a press, rather than a pan break, to make the bends. If the spacebar slot needs those braces to strengthen it during the bending process, maybe we should just eliminate the slot altogether.