Author Topic: PGA Profile Specifications  (Read 770 times)

0 Members and 1 Guest are viewing this topic.

Offline orangesnow

  • Thread Starter
  • Posts: 1
PGA Profile Specifications
« on: Fri, 11 February 2022, 19:37:48 »
I'm trying to make a few keycaps and can't find any information or model files for the PGA profile.

The initial plan was to use MT3, for which there are STL files available. The height and width difference is too noticeable though.

Worst case there's no information on PGA and I send it out to get scanned, unless there's a better method.