« previous next »
Pages:  [1]     Go Down

Author Topic: Help with Red Scarf 68  (Read 1897 times)

0 Members and 1 Guest are viewing this topic.

Offline thebeano77

  • Thread Starter
  • Posts: 3
Help with Red Scarf 68
« on: Wed, 14 December 2016, 21:01:09 »
Hi guys,

I built a Red Scarf 68 yesterday and everything was working well, but I didn't like the default layout, so I decided to reflash with TMK. After reflashing, none of the keystrokes on the board are registered and the computer doesn't even recognize it's plugged in. I've tried on a few computers with no luck. I can't enter reflash mode either, so I can't reflash the default hex.

Am I in luck, or did I brick it?
Logged

Offline Tactile

  • Posts: 1434
  • Location: Portland, OR
Re: Help with Red Scarf 68
« Reply #1 on: Thu, 15 December 2016, 00:47:21 »
Is there not a hardware button on the PCB to trigger bootloader mode?
Logged
REΛLFORCE

Offline Jumie

  • Posts: 298
  • Location: Dangerously Beautiful
Re: Help with Red Scarf 68
« Reply #2 on: Thu, 15 December 2016, 04:17:56 »
Pressing Esc key while plugging the usb will enter to bootloader menu. Have you succesfuly print the hex file via notepad by choosing generic printer?
Check also the usb female header, mine was a bit loose so that I have to put additional solder to hold it in place.
« Last Edit: Thu, 15 December 2016, 04:19:30 by Jumie »
Logged

Offline thebeano77

  • Thread Starter
  • Posts: 3
Re: Help with Red Scarf 68
« Reply #3 on: Fri, 16 December 2016, 17:35:30 »
None of the keys register.
Logged
Pages:  [1]     Go Up
« previous next »