I imagine this would been much more popular if available in TKL, very solid build and cheaper then diy build with GMK keycaps and aluminium case(well, can't use custom firmware though). If I can order this with MX green I'll buy another one. Came with (likely re-tooled) blue, very smooth. It has very complicated macro function too, hasn't tried it yet.
Negative angle by default?
You can make tilt more to any angle you want, can be negative angle no matter how tall you are.
Black PCB.
No pinging thank to thick PCB mount, people who think even leopolds are too loud shoud get this. No flexing at all.
Attached pdf is the manual for macro function.
Edit 1: Pigment swirl at I key can be only seen with strong lighting, actually very common seen in most injection molding products. Not going to exchange it as it's very very minor. Very deep scratch(shrinkage?) on num Del, nevermind.
Approximate cost for similar diy build:
Case €130~160 for similar quality aluminium case,
super thick PCB(partially programmable) 40~70€,
GMK stabilizer €18~20,
GMK base set inc numpad keycaps €130,
very decent stock usb cable €8~12,
multi channel bluetooth module €5~8
Custom plastic feets *8 €32~64? mass production should cost less then €4 each, never seen one my self.
Aluminium feets(non adjustable) *4 €16~24
Final cost is around €347~464 + build + shipping, that's how cheap large volume production is/expensive is custom build/rapid prototyping is
SMD jumper replacing stock controller with custom firmware any one?