hey folks,
sorry, i've been sick for the last week. i'm getting ready to kick off gasket production. bunny and i also need to powow on the pcbs. i currently have:
1. about 20 more raw titan plate sets that need to be prepped (i've prepped about 10-15)
2. 40 plate sets at the painters. there are also about 8-10 units there that will be painted with test colors as samples. it turns out that i should have gotten cleanup on both sides, as about half the top plates must be painted, because they have no finish on the "up" side. oops
3. enough USB jacks for everyone
4. enough stabilizers for everyone
5. no notched plates.
6. a few sample gaskets that give 2 good options. i'm going to go with the more durable and easier to produce of the two.
i don't have:
1. the whole run of gaskets
2. fasteners and spacers
3. PCBs
4. diodes
5. teensies for those who ordered them
6. notched plates for those who ordered them.
that's the current sitrep. because i'm so behind on work, i need to dig into that for a while, so i'm going to focus on low-effort kickoffs like the pcbs, gaskets. those have a few weeks lead-time, and in the meantime the complex stuff can be plowed through as time allows.