I am planning on making a universal case + plate for 60%
These are going to start out as layered designs, which could be used for aluminum/steel/acrylic cases and later we can combine layers and come up with machined cases similar to what Photekq has been working on.
What I have in mind is the case with a plate would allow for PCBs from GH60/Poker/Poker II/Pure. We can have a variety of layouts like the GH60 plates by WFD. The case only option would allow you to fit the GH60 plates by WFD and also the Poker II plates.
I know we might not end up with a universal case, but we can with a universal design, where small tweaks like position of certain cutouts have to be changed.
What were are looking for thus are:
- PCB layouts
- Plate layouts
- Location of USB cable, usb connector of any sort
- Dipswitch positions
- Teensy controller button position
- Any other cutouts required
For the following keyboards:
- GH60 PCB and plates (WFD's)
- Poker PCB
- Poker II PCB and plate
- Pure PCB
- Pure Pro PCB and plate
I would do all this myself, except I have no 60% board, the GH60 PCB and Plate dimensions are available online, so I can handle that,
If members can club in and get the required data, I'll get atleast the layered case ready for the 60%, this will all be open source ofcourse.
Compatibility for universal design so far: