Hello!
Would like to check interest for a custom PCB for Rama M10-A and M10-B.
Planned PCB will have:
- Kailh Hot Swap Sockets
- RGB LED under each key (not per-key addressable RGB)
- USB-C (pending prototype fit, M10-A is mirco-usb but looks like USB-C could fit)
- Stabilizer support for 2U key
- QMK (and hopefully Via support)
- Black PCB, white slikscreen, immersion gold
- Other suggestions people might have.
In addition, I'd like to make brass plates. I think it works a lot better with hotswap when there is a plate. My plan is to have screw holes in the PCB and then 3.5mm standoffs for the plate to screw into. This idea is pending a prototype of course
I don't think this will be a large GB, I'm expecting around 10-15 PCBs. PCBs will be made in China (allpcb) but assembled, QC'ed, and shipped in/from Denmark.
Group Buy will be run 100% at cost. PCBs will be made open source after the GB concludes.
Let me know what you think!