Unfortunately I have tried everything I know to do to rehab and get my PCB working properly, but no luck...
Although I hate to even ask this. Does anyone have any ideas (DIY or otherwise) on how I could potentially buy a third party PCB (and plate if necessary) that would fit in the Exent? Its not the ideal solution but I'm low on options.
TL;DR
Could another PCB fit the Exent plate? If not, is there a third party plate I could use (even if I had drill screw holes, etc)
Thanks in advance!
Sent from my Pixel 2 XL using Tapatalk
the catweewee guide isn't working can anyone help me out with programming?
following the guide i don't get the BAD all across the table but otherwise it flashes and some keys type numbers like .0,12..0,13..0,12.
any help would be appreciated.
I've also tried all the advice so far given through Reddit links, Github, etc and still no luck.
I have downloaded the Bootmapper client from WKL for macOS.
Cleared the EEPROM and 'firm up' with the NKRO.hex file.
After this, the mac just does not recognise the board at all.
I have tried different usb sockets and different cables.
Tried LCTRL for reset as well as 'U' + 'P' and '0' - nothing works.
I also downloaded drivers for atmel chips.
My next thought is to try using a PC (instead of mac) however I do not have access to one.
Can anyone please help? I just need the mac to recognise the board to start with and I might be able to at least do something after this point. Are there any pins that would reset the board?