I got my walnut and ash cases today. They look very nice. Just like the photo in the original post.
Just a word of caution about PCB compatibility. The standoffs used in the case are wooden with a brass receptacle in the middle. You will need to be careful out since the radius of the wooden part is fairly large. Because of this, some PCBs might not work without a few adjustments. There are some small nylon washers included with the board. I assume they anticipated interference with some PCBs. However, the washers don't seem to be thick enough to alleviate the issues on the Nerd PCB.
Tested PCBs that work without adjustment:
Sprit FaceW
Zeal 60
Satan 60
GH60 Rev C
PCBs with issues:
Pok3r (no room for the dip switch) You could probably carve out space or and/or add washers to the standoffs to make it work
Nerd 60. A few of the standoffs come into contact with the diodes on the back. You could dremel a lot of the standoff away and it would work fine.
I'll try to post a few photos later. Office in disarray from trying things out and I have to get it picked up first