I have about 15 more boards to review and check. I need a complete list of which items have exactly what issues as I've found the number that the factory has used doesn't match with the sheet I gave to them. Should be able to finish tomorrow.
At the moment, 6 boards have issues that are outside of finishing that either can't be repaired with cera or affect functionality. Includes issues such as tap marks on the top (from being tapped too far) and dents on mating surfaces. I've included some pictures of some issues, both in the major and minor catagory.
As soon as I have a catalog of what exactly has issues, I'll put together a spreadsheet in the same fashion as I did with Lunar. Serial numbers will be matched with order numbers and emails will be sent to those applicable.
There's only a single board with this issue and I have a replacement bottom for this one.
Gives you an idea of what issues were present with the factory. Interestingly, there were some that turned out absolutely pristine as well as one or two that looked like this.
Screw hole for this one wasn't countersunk right and came out like this. It still works fine and is interal but will be checking in with the owner of this.
Some tops had this issue with overshoot, even after explaining to the factory and pointing out the issue multiple times.
As illustrated above, most of these issues are surface blemishes, though a good number of these have incomplete threads which I'm tapping by hand to get the halves to fit together.
And once again, thanks for everyone's patience. I'll update continually as I work through the boards.