So I'm gonna be building up my E6.5 between today & tomorrow, but have a few questions. I want to use the gasket mount, but have heard of some gasket mounted boards not working with GMK screw-in stabilizers. Is that the case with this board or will I be fine using them? I do have a set of Cherry clip in PCB mount stabilizers, but would much prefer to use the screw in ones if possible. Also I am planning on using MK Ultra plate & case foams with this build. Will the plate foam interfere with the gasket at all? I figure that is not as big as an issue as the stabilizers since I can just trim the edges of the foam back to allow room for the gasket if need be, or even just drop the plate foam & go with the sorbothane strut mod. Anyways, any info from anybody who has built theirs already with the gasket mounting would be highly appreciated!