geekhack
geekhack Projects => Making Stuff Together! => DIY Discussions ARCHIVE => Topic started by: ishtob on Mon, 05 December 2011, 13:18:15
-
Step 1: use a pencil to mark down width of the latch
(http://i6.photobucket.com/albums/y222/icbob/22a24264.jpg)
Step 2: Cut
(http://i6.photobucket.com/albums/y222/icbob/b487734a.jpg)
Step 3: Test and enjoy :D
(http://i6.photobucket.com/albums/y222/icbob/5e096167.jpg)
-
Now I have a reason to have 1000000000 picks lying about. Good tip!
-
making putting together ergo clears for my DOX so much easier
-
So resourceful haha. Would this work on switches that are already soldered on? Right now I'm using two small screw drivers and let me tell you its a PITA.
-
Yeah opening a standalone switch is not a problem. It's the ones attached to the PCB that are a pain.
-
bend the end back maybe?
-
braiiins, i have a method to use only 1 screw driver to remove the top from PCB mounted switches... i actually find it easier to do than these detached ones
-
braiiins, i have a method to use only 1 screw driver to remove the top from PCB mounted switches... i actually find it easier to do than these detached ones
Do tell! I opened up a bunch of PCB mounted ones using a flathead screwdriver placed between the two parts that snap around and popping it off, but it wasn't all that easy.
-
the trick i found is to depress the stem first then insert screw driver to either one of the upper tabs. pull up on that side and hold it, and now do the other upper tab.
-
i swap a keyboard like this in ~30 min
-
the trick i found is to depress the stem first then insert screw driver to either one of the upper tabs. pull up on that side and hold it, and now do the other upper tab.
By upper tab do you mean the plastic around the center you can hook under now that the stem is pushed down and out of the way? I'd be worried about damaging it I think, though I guess you had no problems with that.