Today I came to the conclusion that my F122 is too wide to use at job since I use the mouse too much and it starts to put too much stress on my back because I am not in a good position. So I decided to take the time to put a Soarer in one of my XT. And for this one I wanted to do it all internal. So I loaded the Soarer on my promicro, cut some female-female DuPont cable so that I could solder 1 end directly on my promicro. Soldered it, put it in the XT, tested it, all was working and I was super happy. So then I put some hot glue to fix it, closed it and tested it and BANG it was not working. So I open it up again and see that one cable has broken where it had been stripped and soldered.
So I came to the conclusion that I should not have done it this way ... sniff
Lesson learned. I ordered some female-male DuPont cable. Now time to wait ... grrrrr!