Since A lot of people have received their RJ, Here is some very important instructions.
1, Although i do not suggest to use the diffuser,but if you have to use it,read this:
When you using the diffuser, the top case will raise around 3mm(that how thick the diffuser is). So we have to raise the PCB a little by using the shim i put in with the rubber mat and stuff. Each shim is 1mm thick so using at least 2 at the same time. Put them on the Locating column and screw the PCB,then you good to go. ps.using black ones,they are longer
btw, you can add another RGB strip on the back of the PCB when using diffuser.
If you not using the diffuser, using silver screws.
2, peel off the layer before you using the PC plate and diffusers(i have peel off some diffusers).
3,Try to use hand-made cables. The mini port is usually smaller. It may not work with some normal cables.
PS.All 3M rubber is cut by hands since we couldnt find the right size. It may be a little ugly.
PM me about anything you want to know about how to assemble it.
