Hi all I am going to be getting my hands on a couple of the HAUS alt controllers in a few days and have been reading the documentation. I have found some of it confusing to find the best method for flashing the controller with a custom layout using a linux system. I have tried to write a step by step that I hope to improve on in the future and it has some big holes in it. Could you please help me fill in these holes so that I am ready to go when my controllers arrive? This is as far as I have got
--------------------------------------------------------------------------------------------------------------------------------
HAUS alt controller Step by Step linux (opensuse) for HHKB pro 2
1. Download DFU-programmer.
https://dfu-programmer.github.io/2. Extract it into a directory. I picked with
# tar -xzf dfu-programmer-<version>.tar.gz
# /home/thomas/bin/
3. Install needed extra software. I had to install libusb-1_0-0 and lisbusb-devel. I did this using software management
in yast.
4. cd into dfu-programmer folder.
# cd dfu-programmer
# sudo ./configure
# sudo make
# sudo make install
4. Move back to /home/thomas/bin directory (your equvilant of)
# mv /home/thomas/bin
5. Git clone the software. Make sure git is installed.
# sudo git clone
https://github.com/tmk/tmk_keyboard6. Make you custom layout using keymap editor.
http://www.tmk-kbd.com/tmk_keyboard/editor/hhkb/index.htmland download the hex file
7. ......
-----------------------------------------------------------------------------------------------------------------------------
As you can see I still haven't worked out the next step correctly get the hex onto the board.