Small update: I've confirmed that the
DIY kit is now $15, down from $22. The PCB is almost complete, but there is a last minute change to the USB connector because the fab is unable to source our current one intended for the PCB. A few more days for this.
In the meantime, a lot of people need to look at your orders for stabilizers before I finish tallying them:
Yellow = your stabilizer order is not counted yet, either because 1) you need to specify plate-mounted or PCB-mounted for cherry stabilizers, 2) you need to specify wire size, 3) specify costar or cherry.
orange = your stabilizer order was counted, but there are discrepancies with the plate matching the stabs.
Order confirmationI've spent over 3 hours adding them up already, but I cannot spot-check hundreds of orders. After a couple days, I will make an educated assumption, or just default these orders to cherry PCB-mounted stabs with 6.25x wires. Please check over your order again, even if I didn't mark it. Submit an order change and write "stabilizer" in the "what you want to change" section, and put in your new stabilizer order in the last section.
Order ChangesJust to reiterate again:
Universal plates must use
cherry PCB-mounted stabilizers.
Costar stabilizers are
not currently not available in
7x sizes. Here are the plates that fit each wire size:
6.25x- ANSI 1.25x
- ANSI 1.25x with short R-Shift
- ISO 1.25x
- Samwisekoi
- GH60
- Universal ANSI
- Universal ISO
7x- ANSI 1.5x
- ANSI 1.5x with short R-shift
- ANSI 1.5x with short R-shift and split backspace
- ISO 1.5x with short R-shift
- Universal ANSI
- Universal ISO
- Universal 10x spacebar