So mine is all built and programmed now. Very happy with it





It just has stock retooled mx blacks because this is my gaming keyboard
Things I like:
Very low profile, it is impressive how small this board is especially given that it isn't a tray mount
Seams between top and bottom are very small and line up great
Finish is very smooth (noticeably nicer than 360c, mira, lz gh v2, etc)
Heavy (4lbs built)
Things that could be improved:
Plate is pretty snug inside of the top half of the case, have to push down on it somewhat hard to get it to go all the way into the top
Plate switch holes were on the slightly snug side, not too hard to press switches into though (might just be a preference thing)
Little scratches here and there (One scratch on back side of case, shown in 2nd pic. Scratch on plate by the noxary logo. Scratch on brass plate on bottom of board, shown in 4th pic.)
Resistors maybe could be tweaked:
I think the resistors could be changed to allow for better backlighting. Right now my LEDs are incredibly dim even at the highest setting, dimmer than how bright these LEDs were on the lowest possible setting on the 1UP 60 PCB they were on before.

When I have more time I will try to swap them out for something else.