I appear to be having some problems with this, and I'm not sure if it's the keyboard or my converter. I decided to try one of the eBay converters, as I haven't really had time to make things lately.
The keyboard I'm using it with is a 122-key Computer Lab International with a five-pin AT.
When I first plugged it in (sadly didn't have HID Listen running) the keys seemed all off, and kept repeating (as if I held down the key). Not a big deal, I figured. Ran HID_Listen, recieved a keyboard ID of 0000, but keypresses would register as different keys and seemed to be reading in okay. No big deal, I figured. I'll just make a config with 'force set3' in it and send it over using scaswr.
After doing that, I've only been able to get this from HID_Listen:
The first line of error codes, which show up when I connect the board:
wF8 W085wF8 W085wF8 W085
The rest of the output is what happens when I press a key - any key. No matter what key is pressed, one line of this shows up:
R06 wFE
R06 wFE
R06 wFE
R06 wFE
R06 wFE
R06 wFE
Any help would be greatly appreciated!
I tried sending Halvar.sc and dvorak.sc using scaswr as well, but they resulted in the same output.
Edit: Some more information as I try to figure out what's going on:
Rebooted my computer, and keyboard changed back to Code Set 1 - The keypresses you see here are the result of my typing 'test'
After typing that, the keyboard again acted like I was holding down a key. In this case it was k. No keypresses are registering, but if I go into any window with a field that accepts characters, it's automatically filled with 'kkkkkkkkkkkkkk' and I had to unplug the keyboard for it to stop. On plugging it back in, I get this:
And here's the output of scinfo: