geekhack Community > Off Topic
First Post
bhtooefr:
Adding N-key rollover to a keyboard is a bit more complicated than that, though.
lowpoly:
The Toshiba board I used was fully equipped with diodes. :p
And the new controller should support it, it's listed as a feature.
I have a Cherry G80-1800 that was used as a POS board. It has a 3rd party controller. That controller has diodes in line with the columns and rows. Not sure if both. But the diodes are on the controller pcb. I wonder if that's enough for nKey-rollover. It would be a lot easier to add afterwards.
I know that pex raised the diode question a couple of times but it has never been discussed in-depth.
lowpoly:
Put the G80-1800 through the nKey-rollover test with bad results.
Navigation
[0] Message Index
[*] Previous page
Go to full version