Will Teensy++ 2.0 development board fit in the XenGi's Teensy footprint?

[SCWes]

Just wondering if I buy https://www.pjrc.com/store/teensypp_pins.html and use https://github.com/XenGi/teensy.pretty for the teensy ++ 2.0 footprint, are the pins small enough on the development board to fit the holes? I would think if the pins go in the teensy to begin with, they must be the same size on the protruding side, no? Just making sure.

[Findecanor]

Normal header pins may have a square cross-section, but are less than 1 mm on the diagonal, so I think so.

[kkatano]

Just wondering if I buy https://www.pjrc.com/store/teensypp_pins.html and use https://github.com/XenGi/teensy.pretty for the teensy ++ 2.0 footprint, are the pins small enough on the development board to fit the holes? I would think if the pins go in the teensy to begin with, they must be the same size on the protruding side, no? Just making sure.

I recently used XenGi's teensy2.0 footprint (not ++ but both seems to have same hole size) on my project. The hole fits teensy's pin well.

[SCWes]

Great! Thanks for the reply.