So I've had a white GON Nerd60 Mekanisk edition from 1upkeyboards in an Fjell for about 6 months, and it's been working flawlessly......
Until yesterday.
Here's the timeline:
1. Spacebar stops working
2. Reflash, no dice
3. Look at joints, solder looks good
4. Replace switch, still no dice
5. Start messing around with software, realize that no switches east of left winkey work
6. Diodes look fine
7. Switches look fine
8. Check continuity between switches
9. Get a high resistance from one switch terminal to the next switch. I don't have a pic, so I'll attempt to ascii it (looking at it from the bottom of the pcb, o's being switch terminals):
space* alt* winkey ctrl
-----o------0Ω------o------30MΩ------o------0Ω------o
--------o--------------o----------------o---------------o
*not working
I'm no electrician, but all the traces look good as far as I can tell.
At this point, I'm not really sure where to go next. or if the pcb is bad.
Should I try to jump the high resistance terminals?
Many thanks for any support.