« previous next »
Pages:  [1]     Go Down

Author Topic: Pok3r spacebar LED issue!  (Read 1810 times)

0 Members and 1 Guest are viewing this topic.

Offline NolandC

  • Thread Starter
  • Posts: 2
  • Location: Toronto, Ontario, Canada.
Pok3r spacebar LED issue!
« on: Fri, 26 January 2018, 15:22:13 »
Hey guys I recently got a new Vortex Pok3r and have noticed the two spacebar led's have some issues.  I was wondering if anyone has had this issue and or know of a fix? The link is to a video of my keyboard.
https://photos.app.goo.gl/ARePou0rOrO5iIfq1
Logged

Offline Hyde

  • Posts: 2643
  • Location: Toronto, Canada
  • White Tofu Extraordinaire
Re: Pok3r spacebar LED issue!
« Reply #1 on: Sat, 27 January 2018, 14:10:23 »
I'm not 100% sure but maybe double check Pok3r manual and see if you were stuck in some sort of programming mode.

I know the bottom 2 LED generally only light up if you're try to set special programming.
Logged

Archiss ProgresTouch Retro - Gateron Yellow  |  Topre Realforce 104UW - 45g Silent  |  Topre Type Heaven  |  Beige Filco Ninja 104 - MX Red  |  Das Keyboard - MX Brown  |  Poker II - MX Red  |  Race II - MX Brown  |  Matias Quiet Pro - Matias Dampened ALPS  |  Logitech K840 - Romer G  |  Cherry MX Board 2.0 - MX Red  |  Cherry G84-4100 - ML  |  IBM Model M
Roccat Kone Pure  |  Logitech G203  |  Logitech G303  |  Logitech G302  |  Razer Naga  |  CM Storm Xornet  |  Razer Goliathus Mobile Stealth  |  Razer Goliathus Control  |  Artisan Hien  |  Artisan Hayate  |  Artisan Shiden

Offline NolandC

  • Thread Starter
  • Posts: 2
  • Location: Toronto, Ontario, Canada.
Re: Pok3r spacebar LED issue!
« Reply #2 on: Mon, 29 January 2018, 11:26:26 »
Quote from: Hyde on Sat, 27 January 2018, 14:10:23
"I'm not 100% sure but maybe double check Pok3r manual and see if you were stuck in some sort of programming mode.

I know the bottom 2 LED generally only light up if you're try to set special programming."

Hey Hyde thanks for the reply.
 I have verified that the programming mode is not the problem by factory resetting the firmware. I have also updated the video to show the issue a little better. I think I'm going to have to open her up and check out the solder points. I'll post my findings for anyone interested. 
Logged
Pages:  [1]     Go Up
« previous next »