Ladies and gentlemen I figured it out,
Listen to my yarn...
Based on the fact that a small section of the resistors heating up I figured the issue must lie at one end of the parts in question, a short maybe. On the right side there was nothing that could cause it, on the left, Zeal Screw in Stabs.... Sure enough they cause a short when screwed into the Enter key position on the octagon PCB. What a novel issue.
This is a word of warning, make sure you put an o-ring or something similar when you use screw in stabs on any Duck PCB where the traces pass around the stab hole.
Thanks for everyone who checked out my issues.