Picture of final product - 62g ergo clear, TEX case from MechanicalKeyboards.
Thanks again to strict for this group buy.
Show Image
The TEX case works with Phantom well?
Looks like it. Which is good to see because I plan on using one of these cases as well.
Nice board echo0!
Thanks!
It was a tight fit into TEX case. When I put the keyboard (plate and pcb with switches soldered) into the bottom case, the plate wobbled a bit when I touched it. But once the screws are in place to close the case with top cover, everything seemed fine.
In order to make use the mini usb connector come with the TEX case, I used a 5-pin connector header (digi-key part number A100099-ND) and mini usb plug to make a custom adapter cable with 5 thin wires. Soldering thin wire onto the 5-pin connector header and mini usb plug was not easy for me.